Me Subsystem; Server Mgmt Menu - Inspur NF5270M3 User Manual

When this option is set to 【 Disabled 】 , it could be used as a storage drive
via connecting 4 SATA hard disks. If it is required to connect SAS hard driver use
connected SATA hard drives system disk, this option should be set to 【 Enabled 】 .
* Onboard SATA RAID Oprom
This option is used to open or close integrated SATA RAID controller ROM,
there're two options of 【 Enabled 】 (default settings) and 【 Disabled 】 .
● ME Subsystem
This menu is used to set ME subsystem.

* ME Subsystem

This option is used open or close ME subsystem, when set to 【 Enabled 】 (default),
users could view related ME information.
IV. Server Mgmt Menu
● Wait For BMC
This option is used to set whether to wait for BMS startup, there're two options of
【 Enabled 】 and 【 Disabled 】 (default settings).
● System Event Log
This menu is used to set system even log features, modifi cation on settings made
in this menu could only validate after reboot.
* SEL Components
This option is used to set whether to record all event logs during system startup,
there're two options of 【 Enabled 】 and 【 Disabled 】 (default settings). If set to 【 Enabled 】 ,
settings on cleaning methods for system event logs etc. could also be carried out.
* Erase SEL
For settings on system event log erasing methods, there're the following three options:
【 No 】 (default): No log erasing.
【 Yes,On next reset 】 : Erase logs during the next reboot.
【 Yes,On every reset 】： Erase logs during each reboot.
* When SEL is Full
For erasing methods when system event logs reach the maximum recording
number, there're the following two options:
【 Do Nothing 】 (default): Do nothing.
【 Erase Immediately 】 : Erase logs immediately.
● BMC network confi guration
This menu is used for information confi guration on BMC network interface.
Chapter Three System Setup Chapter Three System Setup
19