Install The Server To Cabinet - Inspur NF5270M3 User Manual

Chapter Eight Server Installation Guide Chapter Eight Server Installation Guide

8.5 Install the Server to Cabinet

1. Raise the server and carry it close to the cabinet, and align the back of the
server with the front of the cabinet.
2. Clamp the inner rail at both sides of the server into the outer rail groove of the
cabinet (the sliding bead of the outer rail must be moved to the front end of the outer rail).
3. Refer to (picture 8), keep the server horizontal and push it steadily into the
cabinet. If it is blocked during the pushing, pull forward the bayonet lock at the front of
the inner rail, and at the same time push it into the cabinet.
4. Use fi xed screw (picture 7) to fi x the server to the cabinet through the third hole
(picture 9) in the front of guide rail corresponding to angle rail.
▲ Special notice: if the third hole screw is accompanied with the cabinet front panel,
you may use the accompanying screw to fi x the server to the cabinet in this operation.
Picture 8
Picture 9
62