Attaching/Adjusting The Knee Pad; Attaching The Base Shifter Handle - Invacare GET-U-UP LIFT Maintenance Manual

SECTION 2—ASSEMBLY

Attaching/Adjusting the Knee Pad

NOTE: For this procedure, refer to FIGURE 2.3.
WARNING
Never adjust knee pad while patient is in the
standing position or while the lift is moving.
Always make sure that the adjustment pins are
fully engaged in the height adjustment holes
before use.
1. Pick a height setting that will be comfortable to the
patient and provide the necessary support.
NOTE: The knee pad should be positioned so that the knee portion
of the leg contacts the pad.
NOTE: The upper adjustment pins are typically used for shorter
individuals. The lower adjustment pins are typically used for taller
individuals.
2. Using both hands, pull both adjustment pins outward at
the same time and hold.
3. Position the knee pad to the desired height and release
adjustment pins into the corresponding alignment holes.
4. Check to make sure that both pins are engaged.

Attaching the Base Shifter Handle

NOTE: For this procedure, refer to FIGURE 2.4.
1. Insert the base shifter handle into the cam lock assembly at the back of the base.
2. Align the holes of the shifter handle and cam lock assembly.
3. Tighten the thumbscrew to secure the shifter handle in place.
NOTE: This should prevent the base shifter handle from being removed.
Thumbscrew
™
Get-U-Up Lift
Base Shifter Handle
Cam Lock Assembly
FIGURE 2.4 Attaching the Base Shifter Handle
12
Knee Pad
Adjustment Pin
(1 of 2)
FIGURE 2.3 Attaching/Adjusting the Knee Pad
Part No 1148115