Disassembly And Cleaning; Cleaning Accessories - ELECTRO FREEZE SLX400C Operator's Manual

ELECTRO FREEZE Soft Serve Models SLX400C
8

Disassembly and Cleaning

It is important that the freezer be
disassembled, washed, lubricated and
sanitized before operation.

8.1 Cleaning Accessories

The following accessories shipped with the freezer are necessary for cleaning,
sanitizing and disassembly/assembly.
1.) HC150009 BRUSH. & HC158012
HANDLE. 4-inch diameter with 36-
inch handle, used for cleaning the
cylinder.
2.) HC158077 BRUSH. 9/16 inch with
36 inch handle, used for cleaning the
drain tube.
3.) HC158003 BRUSH. Double end,
1-1/8 inch diameter and 7/16 inch
diameter, used for cleaning the mix
inlet tube, mix feed tube, head and
general cleaning.
4.) HC169374 TOOL - O-RING
Figure 8-1
20
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad
is "OFF" and that the power
switch is "OFF".
3
HC158003 BRUSH-7/16 & 1-1/8" DOUBLE END
HC169374
4
TOOL-O RING REMOVAL
Accessories
The cleaning and sanitizing instructions
explained in this manual are required to
maintain a clean, sanitary freezer. The
freezer should be disassembled, cleaned,
reassembled, lubricated and sanitized
daily to ensure the best possible product
quality and freezer operation.
Persons assembling, cleaning, or
sanitizing the freezer must wash and
sanitize hands and forearms with an
approved sanitizer.
REMOVAL. Aids in removing O-rings
from plungers, dispense head, and
mix feed tube.
5.) HC158000A LUBRICANT - PETROL
GEL Approved lubricant for moving
parts and O-rings. See assembly
instructions for lubricating points.
6.) HC115536 KIT - O-RING. (NOT
SHOWN) This kit contains all
O-rings and seal needing replacement
on a regular basis.
HC158009 BRUSH-4" DIA W/O HANDLE
1
HC158012 HANDLE-BRUSH FIBERGLASS
2
HC158077 BRUSH-9/16 DIA X 36" HANDLE
HC158000A
5
LUBRICANT-PETROL GEL 4 OZ TUBE
184582-01