ELECTRO FREEZE SLX400C Operator's Manual page 57

14.1
Virtual Quality Management (VQM) System
What the Action taken
display in unit when
will read error is
present
Affected side
compressor and
Spigot beater motor
are off, until
condition is reset
Affected side
compressor and
C Spigot beater motor
are off, until
condition is reset
184582-01
ELECTRO FREEZE Soft Serve Models SLX400C
Display Trouble Shooting Messages (continued)
Detailed
description
If unit is in Clean Error will
or Off Mode, unit automatically
will restore in Off reset once issue
Mode. has been rectified
Displays Spigot if
the Left or Right Error will automat-
Side Spigot switch ically reset once
is engaged for issue has been
more than 5 min- rectified
utes.
Method to Probable cause of Error
reset error
1. Plunger is sticking due
to lack of lubrication, worn
o-rings.
2. Plunger push rod is
sticking/not returning
automatically
3. The wrong plunger push
rod is being used.
4. The plunger switch spring
is worn out.
5. The plunger switch is
malfunctioning
1. Plunger is sticking due
to lack of lubrication, worn
o-rings.
2. Plunger push rod is stick-
ing/not returning automat-
ically
3. The wrong plunger push
rod is being used.
4. The plunger switch spring
is worn out.
5. The plunger switch is
malfunctioning
Code
1. Disassemble unit and
check o-rings and ensure
proper lubrication.
2. Check to ensure push
rod is not bent or distorted
in any way
3. Install the correct push
rod or call your Electro
Freeze Distributor to order
the correct push rod.
4. Contact your Electro
Freeze Distributor for
Service.
5. Contact your Electro
Freeze Distributor for
Service.
1. Disassemble unit and
check o-rings and ensure
proper lubrication.
2. Check to ensure push
rod is not bent or distorted
in any way
3. Install the correct push
rod or call your Electro
Freeze Distributor to order
the correct push rod.
4. Contact your Electro
Freeze Distributor for
Service.
5. Contact your Electro
Freeze Distributor for
Service.
Remedy
47