LifeGear 30805 Owner's Manual page 23

level according to the heart rate detected. For example, the resistance level will increase
while the heart rate detected is lower than Target Heart Rate. Also, the resistance level will
decrease while the heart rate detected is higher than Target Heart Rate. As a result, the
user's heart rate will be adjusted to equal the Target Heart Rate.
TRAINING IN RACE MODE:
When the computer screen displays STOP, MANUAL, PROGRAM, WATT, USER, H.R.C.,
and RACE modes, press the + or - key to select the RACE mode and then press the ENTER
key for confirmation. Press the + or - key to adjust SPM (Stroke of Minute) of the Pacer
(Computer) and then press the ENTER key for confirmation. Press the + or - key to set
racing DISTANCE and then press the ENTER key for confirmation. Press the
START/STOP key to start RACE, U (USER) and P (Pacer) symbols will flash to show who
runs first. Resistance level is adjustable in race. End of the race, the result will display
WIN or LOSE on the screen.
USING THE WIRELESS CHEST BELT HEART RATE TRANSMITTER
(OPTIONAL ACCESSORY):
There is a heart rate receiver inside the computer that can receive heart rate signals when
you wear on the wireless chest belt heart rate transmitter. The split window of PULSE will
display your current heart rate figures in a few seconds after you wear on the wireless chest
belt heart rate transmitter.
For proper operation, the chest belt should be worn with the wireless chest belt heart rate
transmitter strapped across the front of your body just above the chest line and must be tight
and properly placed to receive consistent readout. If the chest strap is too loose or
positioned improperly, you may receive inconsistent heart rate readout. The wireless chest
belt heart rate transmitter needs a little body heat and moisture in order to work properly.
Moisture on the rubber electrodes (2 black areas on the reverse side of the belt and either
side of transmitter) is required for proper operation. It is recommended that you wear the
wireless chest belt heart rate transmitter against your bare skin to ensure the function and
accuracy. However if you wish to wear the transmitter over a shirt, moisten the shirt well
under the electrodes.
WARNING: Signal interference in the environment can be due to electromagnetic
disturbances. These may occur near televisions, computers, or cellular phones. Under
interference, the heart rate readings may become unstable and inaccurate.
Wireless Chest Belt
Heart Rate Transmitter
22