Executing Commands Remotely Through Rsh; Resetting The Switch - RuggedCom RuggedSwitch RS1600 User Manual

RuggedSwitch™ User Guide

Executing Commands Remotely Through RSH

The Unix/Dos Remote Shell Facility can be used at the workstation to cause the
product to act upon commands as if they were entered at the CLI prompt. The
syntax of the RSH command is usually of the form:
rsh ipadd –l password command_string
The access level selected must support the given command.
Any output from the command will be returned to the workstation submitting the
command. Commands that start interactive dialogs (such as trace or loop) cannot
be used.

Resetting The Switch

The CLI command "reset" can be used to reset the switch.
where ipadd = The address or resolved name of the product
password = The password for the access level you wish to
issue the command at
command_string = The command to execute
RuggedCom