Management > Snmp > Snmp View Table Settings - D-Link DMS-1100-10TS User Manual

SNMP Global Settings
SNMP Global State
SNMP Response Broadcast
Request
SNMP UDP Port (0-65535)
Trap Source Interface
Trap Settings
Trap Global State
SNMP Authentication Trap
Port Link Up
Port Link Down
STP Port Status Change
LBV Detection
Firmware Upgrade
Click Apply to make the configurations take effect.
Management > SNMP > SNMP View Table Settings
The SNMP View page allows user to define SNMP Views, which can be used to manage the MIB objects
that are accessible to a remote SNMP manager.
Specify to enable or disable the SNMP feature. The default setting is
Disabled.
Select to enable or disable the server to response to broadcast SNMP
GetRequest packets.
Enter the SNMP UDP port number. The value is between 0 and 65535.
Specify the interface whose IP address will be used as the source
address for sending the SNMP trap packet.
Enable or disable SNMP trap notifications from client devices.
Disabling this option means no trap signals will be sent. When enabling
this option, you may choose the type of SNMP traps to enable.
Tick this option to control the sending of SNMP authentication failure
notifications. An authentication Failure trap is generated when the
device receives an SNMP message that is not properly authenticated.
The authentication method depends on the version of SNMP being
used. For SNMPv1 or SNMPv2c, authentication failure occurs if
packets are formed with an incorrect community string. For SNMPv3,
authentication failure occurs if packets are formed with an incorrect
SHA/MD5 authentication key.
Check this feature to enable Link Up traps. Whenever a device
changes status from 'link down' to 'link up', it will send a Link Up trap to
the management station.
Check this feature to enable Link Down traps. Whenever a device
changes status from 'link up' to 'link down', it will send a Link Down
trap to the management station.
Check this feature to enable STP Port Status Change traps. Whenever
a device changes status from STP Port Status, it will send a STP Port
Status Change trap to the management station.
Check this feature to enable LBV Detection traps. Whenever a device
does detect LBV, it will send a LBV Detection trap to the management
station.
Check this feature to enable Firmware Upgrade traps. Whenever a
device does do firmware upgrade, it will send a Firmware Upgrade trap
to the management station.
Table 4.25
40
D-Link DMS-1100 Series User Manual