System > Port Configuration > Jumbo Frame - D-Link DMS-1100-10TS User Manual

The fields that can be configured for Error Disable Settings are described below:
Item
Error Disable Trap Settings
Asserted
Cleared
Notification Rate (0-1000)
Error Disable Recovery Settings
ErrDisable Cause
State
Interval (5-586400)
Click Apply to make the configurations take effect.
System > Port Configuration > Jumbo Frame
The Jumbo Frame page allows user to view and configure the Jumbo Frame settings.
The fields that can be configured for Jumbo Frame are described below:
Item
From Port / To Port
Maximum Receive Frame Size
(1518-9216)
Figure 4.30 – System > Port Configuration > Error Disable Settings
Description
Select to enable or disable the notifications when entering into the error
disabled state.
Select to enable or disable the notifications when exiting from the error
disabled state.
Enter the number of traps per minute. The packets that exceed the rate
will be dropped. The value is between 0 and 1000.
Specify the error disable causes. Options to choose from are Storm
and Loopback Detect.
Select to enable or disable the auto-recovery for an error port caused
by the specified cause.
Enter the time interval. The values are between 5 and 586400
seconds. And default value is 300.
Table 4.14
Figure 4.31 –System > Port Configuration > Jumbo Frame
Description
Specify the port to be configured.
Specify the maximum receive frame size. The range is between 1518
and 9216. The default value is 1536.
Table 4.15
D-Link DMS-1100 Series User Manual
30