System > Time And Sntp > Sntp Settings - D-Link DMS-1100-10TS User Manual

From: Date of the Month
From: Month
From: Year
From: Time In HH MM
To: Date of the Month
To: Month
To: Year
To: Time In HH MM
Offset
Click Apply to make the configurations take effect.
System > Time and SNTP > SNTP Settings
The SNTP Settings page allows user to configure the time settings for the Switch.
The fields that can be configured for SNTP Settings are described below:
Item
SNTP Global Settings
SNTP State
Poll Interval (30-99999)
SNTP Server Settings
IPv4 Address
Click Apply to make the configurations take effect.
Select date of the month that daylight saving time will start.
Select the month that daylight saving time will start.
Select the year that the daylight saving time will start.
Select the time of the day that daylight saving time will start.
Select the date of the month that daylight saving time will end.
Select the month that daylight saving time will end.
Select the year that the daylight saving time will end.
Select the time of the day that daylight time will end.
Select the number of minutes to add during daylight saving time. The
default value is 60. The range of this offset is 30, 60, 90 and 120.
Table 4.21
Figure 4.41 – System > Time and SNTP > SNTP Settings
Description
Select to enable or disable the SNTP state.
Enter the poll interval. The value is from 30 to 99999 seconds. The
default interval is 720 seconds.
Enter the IPv4 address of the SNTP server which provides the clock
synchronization.
Table 4.22
37
D-Link DMS-1100 Series User Manual