D-Link DMS-1100-10TS User Manual page 74

The fields that can be configured for Link Aggregation are described below:
Item
Ling Aggregation Settings
System Priority (1-65535)
Load Balance Algorithm
Channel Group Information
From Port / To Port
Mode
Click Apply to make the configurations take effect.
Click the Add button to add a new entry based on the information entered.
Click the Delete Member Port button to remove the specific member port.
Click the Delete Channel button to remove the specific entry.
Click the Channel Detail button to view more detailed information about the channel.
Figure 4.86 – L2 Features > Link Aggregation
Description
Enter the system's priority value. This must be between 1 and 65535.
By default, the value is 32768. The system priority determines which
ports can join a port-channel and which ports are put in stand-alone
mode. The lower value has a higher priority. If two or more ports have
the same priority, the port number determines the priority.
Specify the load balancing algorithm that will be used. Options to
choose from are: Source MAC, Destination MAC,
Destination MAC, Source IP, Destination IP, and Source
Destination IP. By default, this option is Source MAC.
System ID: The System ID information.
Select the appropriate port range used for the configuration.
Group ID: Enter the channel-group number. This value must be
between 1 and 32. The system will automatically create the port-
channel when a physical port first joins a channel-group. An interface
can only join one channel-group.
Select either On, Active, or Passive. If you selected On, the channel-
group type is static. If Active or Passive is selected, the channel-group
type is LACP. A channel-group can only consist of either static
members or LACP members. Once the type of channel-group has
been determined, other types of interfaces cannot join the channel-
group.
Table 4.56
68
D-Link DMS-1100 Series User Manual
Source