Dms-1100-10Tp; Front Panel; Rear Panel - D-Link DMS-1100-10TS User Manual

DMS-1100-10TP

8-port 2.5GBASE-T PoE+ and 2-port 10G SFP+ Smart Managed Switch.

Front Panel

Power LED : The Power LED lights up when the Switch is connected to a power source.
Fan Error: The Fan error LED lights up when the fan has runtime failure and is brought offline.
Reset: Press the Reset button for 1~5 seconds to reboot the device. Press the Reset button for 6~10
seconds to reset the Switch back to the default settings and led will be solid light with amber for 2 seconds.
Or press the Reset button over 11 seconds to enter the loader mode after device reboot and the led will be
solid light with green for 2 seconds. If the device cannot reboot the Switch, the device will enter the loader
mode automatically.
PoE OK/FAIL: The PoE LED shows the status of the PoE ports, the green light (OK) indicates that PoE work
fine and the amber light (Fail) indicate that the PoE is working abnormally.
Port Link/Act/Speed LED (1-8): The port LEDs indicate a network link through the corresponding port.
Blinking indicates the Switch is either sending or receiving data to the port. When the port LED glows amber,
it indicates the port is running at 100 Mbps or 1000 Mbps. When the port LED glows green, it is running at
2.5 Gbps.
Port Link/Act/Speed LED (9F, 10F): The port LEDs indicate a network link through the corresponding port.
Blinking indicates the Switch is either sending or receiving data to the port. When the port LED glows green,
it is running at 1000 Mbps or 10 Gbps.

Rear Panel

Power: Connect the AC power cord to this port.
Figure 1.3 – DMS-1100-10TP Front Panel
CAUTION: The MiniGBIC ports should use UL
listed Optical Transceiver product, Rated Laser
Class I. 3.3Vdc.
Figure 1.4 – DMS-1110-10TP Rear Panel
4
D-Link DMS-1100 Series User Manual