L2 Features > Fdb > Static Fdb > Unicast Static Fdb - D-Link DMS-1100-10TS User Manual

The fields that can be configured for D-Link Discover Protocol Settings are described below:
Item
DDP Global Settings
D-Link Discovery
State
Report Timer
DDP Port Settings
From Port / To Port
State
Click Apply to make the configurations take effect.
L2 Features > FDB > Static FDB > Unicast Static FDB
The Unicast Static FDB page allows user to view and configure the static unicast forwarding settings on the
Switch.
Port / Drop: Allows the selection of the port number on which the MAC address entered resides. This option
could also drop the MAC address from the unicast static FDB. When selecting Port, select the switch unit
Figure 4.54 – Management > D-Link Discover Protocol Settings
Description
Protocol
Select the enable or disable the D-Link Discovery Protocol state.
Specify the interval in seconds between two consecutive DDP report
messages. Options to choose from are 30, 60, 90,120, and Never.
Enter the appropriate port range used for the configuration.
Select to enable or disable the DDP port state.
Figure 4.55 – L2 Features > FDB > Static FDB > Unicast Static FDB
D-Link DMS-1100 Series User Manual
Table 4.33
47