Technical Support; Important Safeguards And Warnings; A) Environment And The Place Of Installation - SINTERIT LISA User Manual

12)

TECHNICAL SUPPORT

The latest information, technical support, and versions of the manual are available in the
Support tab of the Sinterit Sp.z.o.o. company or by contacting: contact@sinterit.com
The list of distributors and technical support in specific countries can be found at
www.sinterit.com/where-to-buy.
13)

IMPORTANT SAFEGUARDS AND WARNINGS

To ensure safe use of the SINTERIT LISA product, please read and follow the instructions
below.
Keep this manual for future use. Also, be sure to follow all warnings and instructions
marked on the product.
WARNING!

Only trained and qualified personnel should install, replace or service the
equipment.

The device should be installed in accordance with these instructions and by
trained personnel

A) ENVIRONMENT AND THE PLACE OF INSTALLATION


The printer SINTERIT LISA should be placed at room temperature.

The room must be well ventilated adequate to its size.

The product should be placed on a flat, stable surface that extends beyond all edges
of the product. If you place the product by the wall the distance between the product
and the wall should be greater than 50 cm (20 in).

The product will not work properly if it is set at an angle.
ATTENTION!
Do not place or store the product:
 outdoors;
 in areas with high dust;
 in places subject to shocks, vibrations, high temperature and/or humidity,
and extreme changes in temperature and humidity;
 near water, or heat sources;
15