SINTERIT LISA User Manual page 33

9. Using the provided spatula, carefully transfer the entire contents of the PRINT BED to
the plate for carrying the pints, and transfer to the form included in the set. Leave the
cuboid with the print to cool down, for at least one hour (see image 27).
Image. 12. A correct way of taking out the prints from the PRINT BED (points 8-9)).
10. Precisely clean the PRINT BED from the remaining unsintered powder, including that
surrounding the BEDs (it's best to move it to the OVERFLOW BIN and then transfer it
to the form with the print, see image 28).
11. Remove any remaining powder from the SOURCE. This can be done with the use of a
spatula or by moving the SOURCE BED to the top (MECHANICS//SOURCE//▲) and
moving the powder to the OVERFLOW BIN using a spatula. Transfer the powder to the
container with the powder from the OVERFLOW BIN.
Image. 13. Removing the remaining powder from the inside.
33