Working With The Powder; Installing Sinterit Studio - SINTERIT LISA User Manual

STOP!
Do not dispose in municipal waste!
The used polyamide powder should be stored in sealed containers and disposed
in accordance with local policy of waste plastic material.
15)

WORKING WITH THE POWDER

1. Always wear protective clothing (glasses, mask, gloves) when working with PA12 and
other used with the Sinterit Lisa printer.
2. For the first use of the Sinterit Lisa printer use only the container number 2 (PRINT
READY POWDER) if you wish to print using precisely this material.
3. Always pay attention to the messages displayed on the main display of the Sinterit Lisa
printer. The Sinterit Studio software calculates the amount of FRESH POWDER, which
needs to be added to that inside of the printer. Not acting according to the message
may result in the following print being incorrect.
4. Even if you do not intend to make the following print right after the first one, mix both
powders in the proportions given by the Sinterit Studio software. Store in the container
number 2 for the PRINT READY POWDER.
16)

INSTALLING SINTERIT STUDIO

1. Connect the Pendrive included in the set, to the computer USB port.
2. Locate the SINTERIT STUDIO 2016 folder.
3. Click 2 times on the SinteritStudioSetup.exe icon.
4. Select the language for the installation.
5. Act according to the messages on the installation screen***.
6. After the installation, the software is ready to be used.
*** Software compatible with Windows 7 and higher.
IMPORTANT!
Be sure to carefully read the license agreements and accept them.
19