Water Pump - Mitsubishi 6M60-TL Service Manual

WATER PUMP

Disassembly sequence
1 Impeller
2 Flange
3 Snap ring
4 Bearing
5 Spacer
6 Bearing
Assembly sequence
For the sequence not mentioned below, follow the disassembly sequence in reverse.
12 → 8 → 7 → 6 → 5 → 4 → 11 → 3 → 9 → 10
Service standards (Unit: mm)
Location
1, 8 Flange-to-water pump shaft interference
2, 8 Impeller-to-water pump shaft interference
Tightening torque (Unit: N·m {kgf·m})
Mark
Bolt (water pump mounting)
Grease nipple
Lubricant and/or sealant
Mark
Pack in bearing
Fill through grease nipple
Outer periphery of unit seal
14-28
7 Washer
8 Water pump shaft
9 Unit seal
10 Grease nipple <If equipped>
11 Water pump case
12 Gasket
Maintenance item
Parts to be tightened
Points of application
13 Cover
14 Gasket
: Non-reusable parts
Service standard
0.03 to 0.06
0.03 to 0.08
Tightening torque
24 {2.4}
9.8 to 15 {1 to 1.5}
Specified lubricant and/or sealant
Wheel bearing grease
[NLGI No. 2 (Li soap)]
ThreeBond 1102
Limit Remedy
Reassembly
– allowed only
twice
Reassembly
– allowed only
twice
Remarks
–
–
Quantity
As required
60 g
As required