Mitsubishi 6M60-TL Service Manual page 203

Check item
03
Output voltage of accelerator pedal posi-
tion sensor
04
Resistance of fuel temperature sensor (in-
let)
05
Resistance of fuel temperature sensor
(outlet)
06
Resistance of injector magnetic valve
07
Resistance of engine speed sensor
08
Output of cylinder recognition sensor
09
Continuity of accelerator pedal switch
[Conditions]
• Starter switch ON
• Vehicle-side harness connected (Perform inspection on back of connector.)
[Requirements]
Terminals (+)-(–)
A24-D30 (accelerator pedal position sensor 1)
A23-D28 (accelerator pedal position sensor 2)
• With accelerator pedal not depressed: 0.85 ± 0.1 V
• With accelerator pedal depressed: 4.15 ± 0.1 V
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: E30-B27
• –20°C: 15.0 ± 1.5 kΩ
• 20°C: 2.45 ± 0.24 kΩ
• 80°C: 0.318 ± 0.008 kΩ
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: E31-B26
+0.14
• 20°C: 2.45 kΩ
–0.13
• 80°C: 0.318 ± 0.01 kΩ
• 110°C: 0.1417 ± 0.01 kΩ
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals:
D1 or D2-D5 (injector magnetic valve: No. 1 cylinder)
D1 or D2-D3 (injector magnetic valve: No. 2 cylinder)
D1 or D2-D4 (injector magnetic valve: No. 3 cylinder)
E1 or E2-E5 (injector magnetic valve: No. 4 cylinder)
E1 or E2-E7 (injector magnetic valve: No. 5 cylinder)
E1 or E2-E6 (injector magnetic valve: No. 6 cylinder)
• 0.45 ± 0.1 Ω (20°C)
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: B2-B1
• 125.5 ± 17 Ω (20°C)
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: D31-D33 (+5 V to GND)
• 200 to 1800 Ω (Resistance serves as rough indication only. Pulse output moni-
tor is needed for confirmation of functionality.)
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
• Terminals: B20 and chassis earth
• With accelerator pedal depressed: no continuity is found.
• With accelerator pedal not depressed: continuity is found.
Measurement method
13E
13E-45