Mitsubishi 6M60-TL Service Manual page 50

GENERAL INSPECTION AND ADJUSTMENT
11-14
• While holding the adjusting screw in this position with a socket
wrench and extension, tighten the lock nut to the specified
torque using .
CAUTION
• After adjusting the adjusting screw, be sure to tighten the
lock nut to the specified torque. Insufficient torquing will
compromise the parallelism of the valve bridge, damaging
the valve mechanism.
• Screw in or out the adjusting screw on the rocker arm until the
correct feeler gauge can be inserted with a slight resistance.
• While holding the adjusting screw in this position with a screw-
driver, tighten the lock nut to the specified torque using
• Recheck the valve clearance using the correct feeler gauge.
[Installation]
• Install the rocker cover and gasket. (See later pages.)
.