Mitsubishi 6M60-TL Service Manual page 146

[Installation]
• Clean the O-ring contact surface of the water separator body
and the O-ring fitting groove in the cover.
• Replace the element and O-ring with new ones.
• Apply a thin coat of engine oil to the O-ring and fit the O-ring
onto the cover.
CAUTION
• The use of inappropriate element can lead to engine prob-
lems. Be sure to use a genuine element.
• To prevent fuel injection problems, keep the water separator
and fuel hoses clear of fine dirt and other foreign matter.
• Using the with a torque wrench attached to it, tighten the
cover to the specified torque.
• Tighten the drain plug, plug A and plug B to the specified torque.
Then, bleed the fuel system of trapped air.
• Start the engine and ensure that there is no fuel leakage.
• If there is any fuel leakage, remove the water separator and rein-
stall it correctly.
13A
13A-13