Control Panel; Display - Danfoss EKE 347 User Manual

User Guide | Liquid level controller, EKE 347

Control Panel

Display

© Danfoss | DCS (ADAP-KOOL®) | 2016-04
Home Image
The user interface of the control panel consists
of a multiline display and 4 individual push
buttons: Enter button, Scroll up
button, Scroll down button and Back
button.
Controller name
Actual liquid level
Valve opening degree
The display itself show the state of Liquid level,
Controller Mode (controller On/Off), Valve
opening degree, Lower level alarm (off = no
alarm present) and Upper level alarm (off = no
alarm present).
Additional to the external connected alarm
audio/video sources, a Bell symbol will flash in
the upper right corner in case of an alarm.
To see more details on system performance and
setting of parameters, 2 different main menu
levels can be reached by operation of the push
buttons.
Back
Press and hold = Log Out
Scroll up
Scroll down
Enter
Press and hold = Log In
The figure shows the Home display image, which
give the actual overview. This is the starting
point for entering into menus, and you will
revert to this image by pushing
(depending on actual position).
Flashing bell = Active alarm
Controller mode
Lower level alarm off (pump on)
Upper level alarm off
From Home image the Status menu can be
reached by 1 push on Enter.
From Home image the Setup & service menu
can be reached by 1 push and hold on Enter.
For entrance a Log In is required by the pass-
word given during Commisioning.
DKRCI.PD.RP0.A4.02 | 4
1 – 3 times