Status Menu; Setup & Service Menu - Danfoss EKE 347 User Manual

User Guide | Liquid level controller, EKE 347
Menus
© Danfoss | DCS (ADAP-KOOL®) | 2016-04

Status menu

To enter Status menu from Home image:
Push once.
The Status menu is an open menu accessible for
all. Therefore only 1 parameter can be changed
from here. A selection of other parameters can
be seen from the status menu.
Status menu ( Open menu )
Setpoint
Liquid level setpoint
Active alarms
Example of alarm content. The list will be empty in normal operation as no alarm is active.
Level signal out of range
Standby mode
Detailed status
Controller state
Actual level
Actual reference
Actual OD
Digital input status
Actual level signal current
Oscillation amplitude
Oscillation period
Controller Info
Type
Name (Controller name)
SW (Software version)
Bios (Bios version)
Adr (Controller address)
SN (Serial Number)
PV (Product version)
Site (Production site)
QR code
Code
Read & Write
Read only
Setup & service menu
(Requires log-in password assigned in
Commisioning menu)
To enter Setup and service menu from Home
image:
Push and hold .
Maneuvering in the Status menu and the Setup
and service menu's are done by use of the 4
push buttons shown on page 4.
The Setup & service menu is divided into 3
access levels, where personnel have individual
authority.
Most advanced level is Commissioning, where
you have access to change all
allowable parameters, including password
issuing and re-run of Setup wizard.
Service level is for service personnel and has
fewer rights than commissioning.
The lowest level is for Daily use, and allows only
a few changes.
The table on the next page shows authority
given to the Commisioning level.
Options
0 - 100%
hours minutes
hours minutes
Stop, Manual, Auto, Slave, IO
0.0 - 100%
0.0 - 100%
0.0 - 100%
On / Off
mA
0.0 - 100%
sec
DKRCI.PD.RP0.A4.02 | 5