Alarm And Error Codes - Danfoss EKE 347 User Manual

User Guide | Liquid level controller, EKE 347
Setup & service menu - COMMISSIONING (Continued)
Parameter
Service Controller state
Actual level
Actual referrence
Actual OD
Actual valve position
Digital input status
Actual level signal voltage
Actual level signal current
Actual position signal voltage
Actual position signal current
Actual OD A
Actual OD B
Actual OD C
Manual Mode
Manual OD
Manual low alarm
Manual high alarm
Manual common alarm
Apply defaults
Setup wizard Setup wizard
I/O check
Main switch EKE act:
AKS 4100 EKE act:
ICAD EKE act:
Nor. Close (NC) EKE act:
Upper lvl (alarm) EKE act:
Lower lvl (alarm) EKE act:
Controller name Controller name
Read & Write
Read only

Alarm and error codes:

When detecting an alarm from external sources or the flashing bell in the display,
the alarm description can be found as a text message in the Status menu under
Active alarms.
Both alarms and errors will be shown here.
If more alarms/errors occur simultaneously, they will be shown as subsequent text
lines.
Alarms:
Upper level
Lower level
Standby mode
Valve B CAN ID conflict
Valve C CAN ID conflict
IO module CAN ID conflict
IO module communication
Communication to master lost
Min/max OD conflict
Common alarm HW conflict
Control method conflict
Multiple valve setup conflict
Valve C alarm
Valve B alarm
Oscillation in level signal
Valve position
Multiple valve capacity
Valve C communication
Valve B communication
Errors:
Internal error
Level signal out of range
Valve position signal out of range
Sensor supply overload
AKS 4100 error
Too much current AI3
Too much current AI4
DO4 overload
© Danfoss | DCS (ADAP-KOOL®) | 2016-04
Options
On, Off
0 - 100%
Off-On
Off-On
Off-On
None, Factory
Re-run Setup wizard
Type in controller name
Default
values
-
-
-
-
-
-
Off
50.0%
Off
Off
On
None
-
Off
-
-
-
-
-
-
DKRCI.PD.RP0.A4.02 | 7