Machine Operation; Powering The Orbital Floor Machines; Pad Drivers, Pads, And Brushes; Filling The Shampoo Tank - Mytee ECO-13 User Manual

2 - MACHINE OPERATION

2.1 - Powering the Orbital Floor Machines

The Orbital Floor Machines require a 20 amp, 115V power
outlet to operate.
Included 50'
extension cord
Plug the female end of the 50' lighted extension cord into
the Orbital Floor Machine's pigtail power cord and plug the
male end of the extension cord into a wall outlet.

2.2 - Pad Drivers, Pads, and Brushes

Pad Driver
The pad driver comes pre-installed on Mytee's Orbital
Floor Machines. To remove the pad driver, undo the four
screws on the bottom of the pad driver.
Applying Cleaning Pad
To apply a cleaning pad, just lower the machine with pad
driver onto a 16" cleaning pad for the ECO-13 or a 19"
pad for the ECO-17. Make sure the pad is as centered as
possible on the pad driver with no driver bristles exposed
to carpet.
Tile & Grout Brush
To apply the optional Tile & Grout Brush, remove the
pre-installed pad driver via the four screws holding it in
place. Screw the Tile & Grout Brush directly into the bear-
ing just like the pad driver was.
Using the Optional Star Lok™ Driver Hub
Quickly switch between the Pad Driver and Tile & Grout
Brush with the A145 Star Lok™ Driver Hub (sold separate-
ly). The Star Lok™ Driver Hub bolts onto the Orbital Floor
♦
Machine's bearing, eliminating the need for tools when
swapping cleaning heads. Just slide one head off of the
star-shaped Driver Hub and slide another on.

2.3 - Filling the Shampoo Tank

IMPORTANT:
When filling with
a bucket, tilt the
handle back in
order to avoid
spilling water on
the motor.
10
♦