Page 1
User Manual ORBITAL Model: ECO-15-24VDC REV. 2/12/18 Battery Powered Orbital Floor Machine 13655 Stowe Dr. Poway, CA 92064 • P: (858) 679-1191 • F: (858) 726-6005...
Page 2
Mytee Products and its employees are equally dedicated to developing with the industry and its advances. Like any other piece of machinery or technology, the ECO-15-24VDC also re- quires proper maintenance and care to keep the product working over extend- ed use.
TABLE OF CONTENTS IMPORTANT SAFETY INFORMATION AT A GLANCE 1.1 - Technical Specifications 1.2 - Included with the ECO-15-24VDC 1.3 - ECO-15-24VDC Front View 1.4 - ECO-15-24VDC Rear View 1.5 - Gravity Feed/Spray Jets Selector Valve MACHINE OPERATION 2.1 - Connecting the Battery Pack 2.2 - Pad Driver and Pads...
When and if calling Mytee for support, please grounding plug. The plug must be plugged into an appro- have your Model and Serial Number available for faster priate outlet that is properly installed in accordance with assistance.
Page 5
IMPORTANT SAFETY INFORMATION product is intended for commercial use only. charging or running the machine. To reduce the risk of fire, electrical shock, or injury: 19. Do not open the battery box, there are no user ser- viceable parts inside. 1.
1,800 Orbit 9/16” Pump PSI Pump GPM Battery Life 1 hour per charge Machine Weight 130 lbs. Machine Dimensions 36” x 15.5” x 48.5” 1.2 - Included with the ECO-15-24VDC Pad Driver Two Cleaning Pads Two Battery Packs Battery Charger...
1 - AT A GLANCE 1.5 - Gravity Feed/Spray Jets Selector Valve Arrow points in the direction of the selected feature. Gravity Feed Spray Jets Water or shampoo solution is pumped down Water or shampoo solution is pumped out of the to the cleaning head, wetting the floor directly spray jets on the front on the machine, wetting under the pad or brush.
2 - MACHINE OPERATION 2.1 - Connecting the Battery Pack Pad Driver The pad driver comes pre-installed on the ECO-15-24VDC. To remove the pad driver, undo the four screws on the bottom of the pad driver. Applying Cleaning Pad To apply a cleaning pad, just lower the machine with pad driver onto a 17”...
2 - MACHINE OPERATION 2.4 - Operating the ECO-15-24VDC Running the ECO-15-24VDC To effectively clean floors, move the machine forwards and backwards, similar to using a household vacuum clean- Switching On the ECO-15-24VDC er. Wet the floor by spraying solution as you roll the unit After connecting the battery pack, lower the handle to a forwards.
3 - BATTERY INFORMATION 3.1 - About the Battery 3. Charge Display - The charge display will tell you how much charge is still in the battery, just like the gas gauge in your car tells you how much gas is left. ♦...
3 - BATTERY INFORMATION 3.4 - Tips For Battery Longevity Lights on battery do not Plug battery into charger turn on when plugged into while the charger is un- charger. plugged from AC power. • Charge the battery every 3 months when it is stored for Only plug charger into an extended period.
Daily Weekly smoothly and reduce the risk of damage to the machine Clean and inspect motor. and subsequent downtime, Mytee recommends following Check power supply cable. the maintenance schedule to the right: Clean machine with all purpose cleaner and cloth.
(see Figure A). Make sure that only the Leak in high pressure hose Check the hose and con- proper Mytee power cord or connections. nections. extension is being used, Filter is clogged. Clean the filter.
Page 17
5 - TROUBLESHOOTING Worn pump seals. Replace with new plunger and seals. Abrasives in solution have Mix chemical thoroughly damaged pump seals. and make sure filter is not damaged.