Page 1
Instructions for Spyder HP60 ™ Please read before use. Register your product at www.mytee.com/help Model # Set up p. 3 General information p. 6 Serial # Parts & pricing p. 9 Form # ADM-HP60 Wiring diagram p. 11 Notes p.12 6-11 13655 Stowe Dr., Poway, Ca.
Page 3
HP60 SPYDER™ FRONT BACK 1. Waist high controls 7. Easy open lid 2. 2” Male Cuff-Lynx™ 8. Motor base housing 3. Female quick disconnect 9. Locking casters 4. Solution tank 10. Vent guard 5. Blower attachment 11. Single 25’ power cord 6.
Page 4
HP60 SPYDER™ ATTACH HOSES PUMP Attach one end of a solution hose to a wand or other tool, the After the machine has been plugged into a 20 amp grounded other end to the Spyder’s™ front quick disconnect. Attach one outlet, turn on pump.
Page 5
MYTEE® SYSTEM MAINTAINER When the float shuts off vacuum, empty tank. Pull lever located at Weekly flushing of the solution system with Mytee® System the back of the machine to release water. Maintainer helps keep lines clean and prevents chemical build-up,...
If damage is evident, save the shipping carton so that it can we at Mytee Products Inc. strive to keep you on the cutting edge with superior be inspected by the carrier that delivered it. Contact the carrier immediately to file a freight damage claim.
4. Filters clogged, remove filters and rinse clean with water. 8. Wait 8–10 minutes for unit to pre-heat. 5. Heater is blocked; flush out with Mytee’s system maintainer. 9. Re-key upholstery tool until hot water begins flowing. 6. If brass check valve is stuck replace valve.
Page 8
EVENT SHALL MYTEE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, PROPERTY DAMAGES, OR PERSONAL INJURIES. All limited warranties are void for, and Mytee does not warrant in any way, any prod- uct that evidences misapplication, improper installation, abuse, lack of maintenance,...
Page 9
HP60 SPYDER™ PARTS & PRICING Order parts at: http://www.mytee.com/products/product.php?id=HP60 Part prices are subject to change.