Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Instructions for
Orbital Encap / Floor Machine
ECO-17
Please read before use.
Register your product
at http://www.mytee.
com/support/register
General Information p. 2
Notes p. 12
13655 Stowe Dr. Poway, CA 92064
1
Model #
Serial #
Form # ADM-ECO17
5-16
Advertisement
Table of Contents
Related Manuals for Mytee ECO-17
Summary of Contents for Mytee ECO-17
-
Page 1: Table Of Contents
Instructions for Orbital Encap / Floor Machine ECO-17 Please read before use. Register your product at http://www.mytee. com/support/register General Information p. 2 Unboxing & Assembly p. 4 Model # Set Up & Operation p. 5 Serial # Flywheel Bearing Replacement p. 9 Parts &... -
Page 2: General Information
NOTE: This machine ships in two boxes. Caution and Warnings Keep in mind that the ECO-17 is a machine, so neglect or abuse will cause un- necessary damage and void the warranty. However with simple maintenance the Symbols ECO-17 will give quality performance for many years to come. -
Page 3: Machine Specifications
Q: Where do I plug the machine in? or pad surface is balanced before starting the machine. A: The ECO-17 requires a grounded circuit. Please note: GFI outlets may trip Your floor machine will operate differently on various surfaces. There will be before the breaker setting. -
Page 4: Unboxing & Assembly
ECO-17 ENCAP MACHINE UNPACKING & ASSEMBLY Tools Needed: The ECO-17 ships in two boxes and will need to be assembled before use. Follow these directions to • 5/16” allen hex key • Needle nose pliers assemble the two pieces. 2. Remove both C-clips from the axle using needle nose 1. -
Page 5: Set Up & Operation
ECO-17 ENCAP MACHINE SETUP & OPERATION FRONT BACK 1. Power Switch 6. Pump 10. Handlebars 2. Handle Height 7. Motor 11. Faucet Fill Hose Adjustment Lever 8. Spray Jets 12. Solution Tank Drain Cap 3. Power Cord Pigtail 9. Solution Spray Levers 13. - Page 6 The pad driver is attached with The ECO-17 features a valve that allows you to switch four bolts (highlighted above). To use a pad, simply lay...
- Page 7 ECO-17 ENCAP MACHINE SETUP & OPERATION ECO-17 CLEANING PATTERN To effectively clean floors, move the ECO-17 forwards and backwards, similar to using a household vacuum cleaner. Wet the floor by spraying solution as you roll the ECO-17 forwards.
- Page 8 ECO-17 ENCAP MACHINE SETUP & OPERATION USING THE ECO-17 ON VARIOUS SURFACES IMPORTANT: Ensure that you are using the appropriate pad type depending on the surface you are cleaning. CARPET STONE TILE & GROUT WOOD EPOXY CONCRETE & MORE VINYL...
-
Page 9: Flywheel Bearing Replacement
ECO-17 FLYWHEEL BEARING REPLACEMENT Tools Needed: CLICK HERE for a quick video on removing the • 3/16” allen wrench • 11mm wrench flywheel plate. • Flathead screwdriver • 15/16” open-ended wrench 1. Remove the pad driver assembly by removing the 4 hex 2. -
Page 10: Parts & Pricing
ECO-17 ENCAP MACHINE PARTS & PRICING... - Page 11 ECO-17 ENCAP MACHINE PARTS & PRICING...
-
Page 12: Notes
NOTES Mytee Products Inc. 13655 Stowe Dr. Poway, CA 92064 www.mytee.com © 2016 Mytee Products Inc. Printed in the U.S.A.