Page 1
User Manual Orbitals Model: ECO14-PRO, ECO17-PRO, ECO-14-LT REV. 2/27/20 13655 Stowe Dr. Poway, CA 92064 P: (858) 679-1191 F: (858) 726-6005 www.mytee.com...
Page 2
Congratulations on the purchase of your new Orbital All-Surface Floor Ma- chine. As technology continues to develop you can work confidently knowing that both Mytee Products and its employees are equally dedicated to develop- ing with the industry and its advances.
Table of Contents Important Safety Information At a Glance 1.1 - Technical Specifications 1.2 - Included with the ECO PRO 1.3 - ECO PRO Front View 1.4 - ECO PRO Rear View 1.5 - Spray Selector Valve Machine Operation 2.1 - Powering the ECO PRO 2.2 - Connecting the Spray Gun 2.3 - Pad Drivers, Pads, and Brushes 2.4 - Filling the Shampoo Tank...
When and if calling Mytee for support, please grounding plug. The plug must be plugged into an appro- have your Model and Serial Number available for faster priate outlet that is properly installed in accordance with assistance.
Page 5
Important Safety Information To reduce the risk of fire, electrical shock, or injury: 18. When cleaning and servicing the machine, local or na- 1. Read all instructions before using equipment. tional regulations may apply to the safe disposal of liquids which may contain: chemicals, grease, oil, acid, alkalines, 2.
1 - At a Glance 1.3 - ECO PRO Front View 1. Handle Height Adjustment Lever 8. Holding Brackets for Optional Weight Set 2. Power Cord Pigtail (on ECO17-PRO only) 3. Faucet Fill Hose 9. Forward-Facing Spray Jets 4. Solution Tank Lid 10.
1 - At a Glance 1.5 - Spray Selector Valve The included spray gun connects here. Arrow points in the direction of the selected feature. Optional Spray Gun Spray Jets Select this feature if you want to use the includ- Select this feature to use the spray jets mounted ed spray gun for pre-spray.
2.1 - Powering the ECO PRO 2.3 - Pad Drivers, Pads, and Brushes Pad Driver The pad driver comes pre-installed on Mytee’s Orbital Floor Machines. To remove the pad driver, undo the four screws on the bottom of the pad driver.
2 - Machine Operation down into the tank. turn on the motor. 4. Use a back-and-forth motion to work encapsulation Bucket Fill chemical into carpet or to scrub hard surfaces. ♦ To fill using a bucket, twist off the shampoo tank cap counter-clockwise and pour in water.
In order to keep the Orbital Floor Machine running smoothly and reduce the risk of damage to the machine Clean and inspect motor. and subsequent downtime, Mytee recommends following Check power supply cable. the maintenance schedule below: Clean machine with all purpose cleaner and cloth.
Page 13
3 - Machine Maintenance 5. Apply blue threadlocker to the two longer set screws (4). 6. Apply a dot of blue threadlocker to one side of the key These get threaded into the holes 90º to the right of the (2) and place it in the key slot on the motor shaft so that key slot.
Check the hose and con- conduit box (see Figure or connections. nections. A). Make sure that only the proper Mytee power cord Filter is clogged. Clean the filter. extension is being used, Pump valves are clogged Examine the valves and and that it is good condi- or damaged.