Related Manuals for Mytee ECO-13
Summary of Contents for Mytee ECO-13
- Page 1 User Manual ORBITAL Model: ECO-13, ECO-17 Orbital All-Surface Floor Machine REV. 3/5/18 13655 Stowe Dr. Poway, CA 92064 • P: (858) 679-1191 • F: (858) 726-6005...
- Page 2 If there are questions regarding maintenance, replacement, or ordering parts please contact an authorized Mytee Products Service Center. To see an updated list please visit our website at http://www.mytee.com/support/service-centers. Before using your Mytee product, please read this manual thoroughly.
-
Page 3: Table Of Contents
TABLE OF CONTENTS IMPORTANT SAFETY INFORMATION AT A GLANCE 1.1 - Technical Specifications 1.2 - Included with the Orbital Floor Machines 1.3 - Orbital Floor Machine Front View 1.4 - Orbital Floor Machine Rear View 1.5 - Gravity Feed/Spray Jets Selector Valve MACHINE OPERATION 2.1 - Powering the Orbital Floor Machines 2.2 - Pad Drivers, Pads, and Brushes... -
Page 4: Important Safety Information
When and if calling Mytee for support, please grounding plug. The plug must be plugged into an appro- have your Model and Serial Number available for faster priate outlet that is properly installed in accordance with assistance. - Page 5 IMPORTANT SAFETY INFORMATION product is intended for commercial use only. tional regulations may apply to the safe disposal of liquids which may contain: chemicals, grease, oil, acid, alkalines, To reduce the risk of fire, electrical shock, or injury: or other dangerous liquids. 1.
-
Page 6: At A Glance
1 - AT A GLANCE 1.1 - Technical Specifications ECO-13 Cleaning Path 13” Solution Tank 4 Gallons Motor 1 Horsepower Pump PSI Pump GPM Power Consumption 20 amps @ 115V 60Hz Machine Weight 100 lbs. Machine Dimensions 26” x 13.5” x 48.5”... -
Page 7: Orbital Floor Machine Front View
1 - AT A GLANCE 1.3 - Orbital Floor Machine Front View 1. Handle Height Adjustment 5. Gravity Feed/Spray Jets 9. Head Rotation Direction Lever Selector Valve Selector Switch 2. Power Cord Pigtail 6. 1 Horsepower Motor 10. 100 PSI Diaphragm Pump 3. -
Page 8: Orbital Floor Machine Rear View
1 - AT A GLANCE 1.4 - Orbital Floor Machine Rear View 1. Solution Spray Levers 3. 10” Foam-Filled Wheels 2. Solution Tank Drain Cap 4. Faucet Fill Hose... -
Page 9: Gravity Feed/Spray Jets Selector Valve
1 - AT A GLANCE 1.5 - Gravity Feed/Spray Jets Selector Valve Arrow points in the direction of the selected feature. Gravity Feed Spray Jets Water or shampoo solution is pumped down Water or shampoo solution is pumped out of the to the cleaning head, wetting the floor directly spray jets on the front on the machine, wetting under the pad or brush. -
Page 10: Machine Operation
Applying Cleaning Pad To apply a cleaning pad, just lower the machine with pad driver onto a 16” cleaning pad for the ECO-13 or a 19” pad for the ECO-17. Make sure the pad is as centered as possible on the pad driver with no driver bristles exposed to carpet. -
Page 11: Operating The Orbital Floor Machine
2 - MACHINE OPERATION Faucet Fill The shampoo tank can be filled from a standard faucet. Simply lift the Faucet Fill hose out of the tank and press it against the faucet. Turn on the faucet to allow water to flow down into the tank. -
Page 12: Machine Maintenance
Daily Weekly smoothly and reduce the risk of damage to the machine Clean and inspect motor. and subsequent downtime, Mytee recommends following Check power supply cable. the maintenance schedule shown to the right: Clean machine with all purpose cleaner and cloth. -
Page 13: Flywheel Replacement
3 - MACHINE MAINTENANCE 3.2 - Flywheel Replacement These instructions cover how to remove and replace the Tools Needed: flywheel assembly on ECO-17 and ECO-13 models. • 7/16” open-end wrench or • Anti-Sieze socket • Flathead screwdriver • 15/16”open-end wrench •... -
Page 14: Troubleshooting
Pump valves are clogged Examine the valves and conduit box (see Figure or damaged. clean or replace. A). Make sure that only the proper Mytee power cord Low pressure. extension is being used, Possible Causes Solutions and that it is good condi- Work nozzle. - Page 15 4 - TROUBLESHOOTING Pump pulsates when spraying. Possible Causes Solutions Filter is clogged. Clean the filter. Pump valves are clogged Examine the valves and or damaged. clean or replace. Leaks seen under pump. Possible Causes Solutions Worn pump seals. Replace with new plunger and seals.
- Page 16 NOTES Mytee Products, Inc. 13655 Stowe Dr. Poway, CA 92064 www.mytee.com © 2018 Mytee Products, Inc. Printed in the USA...