2.1 - Powering the Prep Center S™
To power the Prep Center S™, plug the power cord into a
grounded 20 amp outlet.
♦
2.2 - Connecting Vacuum and Solution Hoses
Connect the vacuum hose via Cuff-Lynx™ connector to
clear elbow on top of the machine. Simply twist the male
Cuff-Lynx™ into the elbow. Connect the solution line to
female solution quick connect fitting on the switch plate.
2.3 - Connecting Shop
Air Line
Shop air input is located in
the bottom-right corner of the
rear of the machine.
Output is located on the
switch plate.
♦
2 - Machine Operation
2.4 - Filling the Solution Tank
Faucet Fill
The solution tank can be filled from a standard faucet or
hose bib. Simply lift the Faucet Fill hose out of the tank
and press it against the faucet. Turn on the faucet to allow
water to flow into the tank.
Bucket Fill
Fill up a bucket with water and pour into the solution tank
through the opening on top of the machine. Add desired
chemical according to manufacturer specifications.
♦
2.5 - Dry Vacuuming
INPUT
IMPORTANT: DO NOT
dry vacuum without a
Piglet™ Filter in place on
the strainer basket. This
will cause damage to the
vacuum motor.
OUTPUT
1. Attach a vacuum hose to
the clear elbow.
2. Switch on the vacuum
and begin vacuuming.
3. Replace the Piglet™ filter regularly.
9
♦
Tank lid
Piglet™
Filter
Strainer
basket
♦