Page 1
User Manual Mytee Lite ™ Model: 8070 REV: 4/19/21 13655 Stowe Dr. Poway, CA 92064 P: (858) 679-1191 F: (858) 726-6005 www.mytee.com...
Page 2
Mytee and its employees are equally dedicated to developing with the industry and its advances. Like any other piece of machinery or technology, the Mytee Lite™ also re- quires the proper maintenance and care to keep the product working over extended use.
Table Of Contents Important Safety Information At a Glance 1.1 - Technical Specifications 1.2 - Included with the Mytee Lite™ 1.3 - Mytee Lite™ Front View 1.4 - Mytee Lite™ Rear View 1.5 - Switch Plate Machine Operation 2.1 - Powering the Mytee Lite™...
When and if calling Mytee for support, please grounding plug. The plug must be plugged into an appro- have your Model and Serial Number available for faster priate outlet that is properly installed in accordance with assistance.
Page 5
Important Safety Information ing: Read all instructions before using this machine. This age. product is intended for commercial use only. 19. When cleaning and servicing the machine, local or na- To reduce the risk of fire, electrical shock, or injury: tional regulations may apply to the safe disposal of liquids which may contain: chemicals, grease, oil, acid, alkalines, 1.
With handle: 33” x 12” x 36.5” Dimensions Without handle: 18” x 12” x 28.5” Power Cord Single 25’ 12/3 1.2 - Included with the Mytee Lite™ 8501 15’ x 1.25” Vacuum & Solution 8400P 4” Air Lite™ Upholstery Tool Heatguard™ Hose Wrap Hose...
2 - Machine Operation 2.1 - Installing the Handle 2.3 - Filling the Solution Tank The Mytee Lite™ solution tank can be filled up via the ♦ Slide the handle into position and line up the holes with faucet fill hose or from a bucket via the opening.
IMPORTANT: Use only low foam or non foaming deter- gent or shampoo. Damage due to excessive foam will void warranty. Cleaning With The Mytee Lite™ For best results when extracting, do one wet pass followed by two dry passes. This ensures you’re not over-soaking the material and keeps water temperature ♦...
Inspect machine for water leaks and loose hardware. 3.1 - Filter Maintenance The Mytee Lite™ has a small filter on the top of the vac- uum stack in the recovery tank. This filter should be ♦ checked and cleaned after each use.
5 - Troubleshooting 5.1 - Vacuum Troubleshooting Vacuum blows water out the exhaust. Possible Causes Solutions Vacuum is not turning on. Foam building up in the Use a defoaming solution Possible Cause Solution recovery tank. in the recovery tank. Vacuum may not be getting Check the electrical con- power.
Page 15
Repair the leak. If there are causing the flow of water water out of the pump out- no leaks, run Mytee’s Sys- to be impeded or stop let hose when the pump is tem Maintainer™ (Part # entirely.
Page 16
140°F water. cord and harness. Heater has hard water Run Mytee System Main- Automatic sensor has Reset the manual sensor tainer™ (Part # 3601) buildup inside, leading to failed, causing manual sen- button by pressing the lost efficiency.