Medium Priority Alarms - ZOLL AEV Operator's Manual

A
LARMS

Medium Priority Alarms

2001 Self Check Fault
Alarm triggers when the communication between the compressor and the SPM fails and high pressure O
available to provide ventilation. The alarm will continue to sound as a medium priority alarm until the user
acknowledges that ventilation is being provided using O
changes to low priority. While operating in this state the user should ensure an adequate supply of O
ure to maintain the O
Mitigation/Info: Pneumatic System: Compressor, Operation Switched to O2 Supply, Set FIO2 to 100%, Moni-
2002
Self Check Fault
Alarm triggers when the communication between the O
able to provide ventilation. The alarm will continue to sound as a medium priority alarm until the user
acknowledges that ventilation is being provided using the compressor by setting the FIO
the alarm priority changes to low. While operating in this state the user should monitor the SpO
that adequate oxygenation is maintained. If low flow O
Gas/Emergency Air Intake port using the optional O
O supply up or down to increase or decrease the amount of O
2
Mitigation/Info: Pneumatic System: Compressor, Operation Switched to O2 Supply, Set FIO2 to 100%, Moni-
2011 Self Check Fault
Alarm triggers when the signal to the O
the compressor is available to provide ventilation. The medium priority alarm will continue until the user
acknowledges that ventilation is being provided using the compressor by setting the FIO
the alarm priority changes to low priority. While operating in this state the user should monitor the SpO
ensure that adequate oxygenation is maintained. If low flow O
Fresh Gas/Emergency Air Intake port using the optional O
adjusting the O
Mitigation: Pneumatic System: O2 Valve, Operation Switched to Compressor, Connect Low Flow O2, Monitor
2012 Self Check Fault
Alarm triggers when the communication between the O
able to provide ventilation. The alarm will continue to sound as a medium priority alarm until the user
acknowledges that ventilation is being provided using the compressor by setting the FIO
the alarm priority changes to low. While operating in this state the user should monitor the SpO
that adequate oxygenation is maintained. If low flow O
Gas/Emergency Air Intake port using the optional O
O supply up or down to increase or decrease the amount of O
2
Mitigation/Info: Pneumatic System O2 Valve, Set FIO2 To 21%, Connect Low Flow O2, Monitor SpO2
5-12
supply will result in a high priority alarm.
2
valve is outside of the calibration range for the required flow rate and
2
supply up or down to increase or decrease the amount of O
2
www.zoll.com
by setting the FIO to 100%. At this time the priority
2 2
valve and the SPM fails and the compressor is avail-
2
is available it can be entrained through the Fresh
2
reservoir. Maintain an acceptable SpO
2
delivered to the patient.
2
is available it can be entrained through the
2
reservoir. Maintain an acceptable SpO
2
2
valve and the SPM fails and the compressor is avail-
2
is available it can be entrained through the Fresh
2
reservoir. Maintain an acceptable SpO
2
delivered to the patient.
2
906-0731-01-05 Rev. C
. Fail-
2
to 21%. At this time
2
to ensure
2
by adjusting the
2
to 21%. At this time
2
2
by
2
delivered to the patient.
to 21%. At this time
2
to ensure
2
by adjusting the
2
is
2
to