Table of Contents
Advertisement
Alarms
Medium Priority Alarms
Service Code
2001
2002
2011
5-22
Alarm Name/Mitigation/Resolution
Self Check Fault - Pneumatic System: Compressor
Alarm triggers when the communication between the compressor and the SPM
fails and high pressure O
2
continue to sound as a medium priority alarm until the user acknowledges that
ventilation is being provided using O
the priority changes to low priority. While operating in this state the user should
ensure an adequate supply of O
a high priority alarm.
Mitigation/Info: Pneumatic System: Compressor, Operation Switched to
O
Supply, Set FIO
to 100%, Monitor O
2
2
Center**
Self Check Fault - Pneumatic System: Compressor
Alarm triggers when the communication between the O
and the compressor is available to provide ventilation. The alarm will continue to
sound as a medium priority alarm until the user acknowledges that ventilation is
being provided using the compressor by setting the FIO
alarm priority changes to low. While operating in this state the user should
monitor the SpO
to ensure that adequate oxygenation is maintained. If low flow
2
O
is available it can be entrained through the Fresh Gas/Emergency Air Intake
2
port using the optional O
2
the O
supply up or down to increase or decrease the amount of O
2
the patient.
Mitigation/Info: Pneumatic System: Compressor, Operation Switched to
O
Supply, Set FIO
to 100%, Monitor O
2
2
Center**
Self Check Fault - Pneumatic System: O
Alarm triggers when the signal to the O
for the required flow rate and the compressor is available to provide ventilation.
The medium priority alarm will continue until the user acknowledges that
ventilation is being provided using the compressor by setting the FIO
this time the alarm priority changes to low priority. While operating in this state
the user should monitor the SpO
maintained. If low flow O
2
Emergency Air Intake port using the optional O
acceptable SpO
by adjusting the O
2
the amount of O
delivered to the patient.
2
Mitigation: Pneumatic System: O
Compressor, Connect Low Flow O
Center**
www.zoll.com
is available to provide ventilation. The alarm will
by setting the FIO
2
. Failure to maintain the O
2
Supply, **Contact Service
2
reservoir. Maintain an acceptable SpO
Supply, **Contact Service
2
Valve
2
valve is outside of the calibration range
2
to ensure that adequate oxygenation is
2
is available it can be entrained through the Fresh Gas/
reservoir. Maintain an
2
supply up or down to increase or decrease
2
Valve, Operation Switched to
2
, Monitor SpO
2
to 100%. At this time
2
supply will result in
2
valve and the SPM fails
2
to 21%. At this time the
2
by adjusting
2
delivered to
2
to 21%. At
2
, **Contact Service
2
9650-002360-01 Rev. A
Advertisement
Table of Contents
