2 G Code
G52 Local Coordinate System Set
This instruction creates coordinate system in the Work Coordinate System.
Modal/Non-modal
Modal group
Instruction format
Relevant G codes
Parameters
Parameter
X
Y
Z
A
B
C
Function
This command adds an offset specified by the parameter to the current coordinate system.
To release the offset, either set it to zero (0) or omit the all axis parameters.
This command releases Scaling (G50/G51), Mirroring (G50.1/G51.1), and Coordinate System Rotation
(G68/G69).
2 - 28
Local Coordinate
System Setting
Name
X-axis offset
Y-axis offset
Z-axis offset
A-axis offset
B-axis offset
C-axis offset
Non-modal
00 Non-modal
Set a Local Coordinate Sys-
tem.
Release a Local Coordinate
System.
G50, G51, G50.1, G51.1, G68, G69, G54 to G59
Description
Specifies an X-axis offset [command units] of the coordinate
system.
Specifies a Y-axis offset [command units] of the coordinate
system.
Specifies a Z-axis offset [command units] of the coordinate
system.
Specifies an A-axis offset [command units] of the coordinate
system.
Specifies a B-axis offset [command units] of the coordinate
system.
Specifies a C-axis offset [command units] of the coordinate
system.
NJ/NY-series G code Instructions Reference Manual (O031)
G52 X- Y- Z- A- B- C-
G52 X0 Y0 Z0 A0 B0 C0