G54 To G59 Select Work Coordinate System - Omron NY532-5400 Instruction & Reference Manual

2 G Code
G54 to G59 Select Work Coordi-
nate System
These instructions change the current Work Coordinate System.
Modal/Non-modal
Modal group
Instruction format
Relevant G codes
Parameters
This command does not have any parameters to set.
Function
Changes the current coordinate system to a specified one defined by the user by using the offsets of
X-, Y-, Z-, A-, B-, and C-axis.
This command releases Scaling (G50/G51), Mirroring (G50.1/G51.1), and Coordinate System Rotation
(G68/G69).
For offset settings of work coordinate system, refer to the Work Coordinate System Offset Parameters
of NJ/NY-series NC Controller User's Manual (Cat. No. O030).
2 - 30
1st work coordinate system
2nd work coordinate system
3rd work coordinate system
4th work coordinate system
5th work coordinate system
6th work coordinate system
Modal
14 Coordinate System Selection
G54
G55
G56
G57
G58
G59
G50, G51, G50.1, G51.1, G53, G68, G69
NJ/NY-series G code Instructions Reference Manual (O031)