Omron NY532-5400 Instruction & Reference Manual page 34

1 Basic Information on NC Programming
Parameter Description
Target X-axis Position [com-
mand units]
Dwell time [s]
X X-axis middle point [command
units]
X-axis center [command units]
X-axis offset [command units]
Target Y-axis position [com-
mand units]
Y-axis middle point [command
Y
units]
X-axis center [command units]
Y-axis offset [command units]
Target Z-axis position [com-
mand units]
Z-axis middle point [command
units]
Z
Z-axis center [command units]
Z-axis offset [command units]
Z-point position [command
units]
ta Acceleration time [ms]
td Deceleration time [ms]
ts Jerk Time [ms]
There is no modal group for feedrate F, spindle rotation speed S, acceleration time ta, deceleration time
td, and Jerk time ts, but it operates as the modal to maintain the commanded state.
1 - 6
Relevant codes
G00/G01/G02/G03 -1,000,000 ≤ X ≤ 1,000,000
G04 0≤X≤100,000
G28/G30 -1,000,000 ≤ X ≤ 1,000,000
G50/G50.1/G68 -1,000,000 ≤ X ≤ 1,000,000
G52 -1,000,000 ≤ X ≤ 1,000,000
G00/G01/G02/G03 -1,000,000 ≤ Y ≤ 1,000,000
G28/G30 -1,000,000 ≤ Y ≤ 1,000,000
G50/G50.1/G68 -1,000,000 ≤ Y ≤ 1,000,000
G52 -1,000,000 ≤ Y ≤ 1,000,000
G00/G01/G02/G03 -1,000,000 ≤ Z ≤ 1,000,000
G28/G30 -1,000,000 ≤ Z ≤ 1,000,000
G50/G50.1/G68 -1,000,000 ≤ Z ≤ 1,000,000
G52 -1,000,000 ≤ Z ≤ 1,000,000
G74/G84 -1,000,000 ≤ Z ≤ 1,000,000
G01/G02/G03 0 ≤ ta ≤ 250,000
G01/G02/G03 0 ≤ td ≤ 250,000
G01/G02/G03 0 ≤ ts ≤ 125,000
NJ/NY-series G code Instructions Reference Manual (O031)
Recommended range