Omron NY532-5400 Instruction & Reference Manual page 86

2 G Code
 An arc is added
Tool center path
Arc added
Cutter
Compensation
Move of
cancel
Detection of Overcut
: Path after correction
: Specified path
When an overcut is detected, the operation stops and an error occurs.
To detect an overcut, set the Overcut operation mode to Overcut detection. For details, refer to the
NJ/NY-series NC Integrated Controller User's Manual (Cat. No. O030).
2 - 48
Corrected linear
interpolation operation
Programmed path
Y
Tool center path
Cutter
Compensation
Arc added
Cutter
Compensation
Move of
cancel
NJ/NY-series G code Instructions Reference Manual (O031)
Corrected
circular
interpolation
operation
Programmed path
X