Tool diameter compensation: Corner circular interpolation (Added Arc)
When the angle of a corner exceeds 270 degrees, this command automatically adds an arc with the
same radius as the cutter radius.
Y
Start of Correction at Inside the Corner
Programmed path
Startup move
Tool center path
NJ/NY-series G code Instructions Reference Manual (O031)
Linear interpolation operation
Cutter Compensation
Startup move
: Path after correction
: Specified path
Programmed path
Cutter
Compensation
Tool center path
2 G Code
Arc added
X
Circular interpolation
operation
2 - 43
2