Parameter List; Table 8: Diagnostic Transducer Block Parameters - Honeywell ST700 User Manual

Parameter List

Parameter
ST_REV
TAG_DESC
STRATEGY
ALERT_KEY
MODE
BLOCK_ERR
UPDATE_EVT
BLOCK_ALM
EL_TEMP_DIAGNOSTIC
SENSOR_DIAGNOSTICS
POWER_TRAC
OP_VOLTAGE
TIME_IN_SERVICE
SENS_TIME_IN_SERVICE
SERVICE_LIFE
SENS_SERVICE_LIFE_HELP
STRESS_MONITOR
SENS_VOLT_DIAGNOSTICS
SENS_GEN_DIAGNOSTICS
UPLOAD_TRACK_DATA
HON_RES_1
HON_RES_2
Page 36 FOUNDATION Fieldbus ST 700 Pressure Transmitter User's Guide

Table 8: Diagnostic Transducer block parameters

The revision level of the static data associated with the function
block.
The user description of the application of the block.
Used to identify grouping of blocks.
The identification number of the plant unit.
The actual, target, permitted, and normal modes of the block.
Reflects the error status associated with the hardware or
software components associated with a block. It is a bit string,
so that multiple errors may be shown.
This alert is generated by any change to the static data.
The BLOCK_ALM is used for all configuration, hardware, and
connection failure or system problems in the block. The cause
of the alert is entered in the subcode field. The first alert to
become active sets the Active status in the Status attribute. As
soon as the Unreported status is cleared by the alert reporting
task, another block alert may be reported without clearing the
Active status, if the subcode has changed.
Electronic Temperature Diagnostic parameters.
Sensor Diagnostics parameters.
Power Up Track Data.
Operating Voltage.
Summation of time in minutes that power has been applied to
the device since leaving the factory.
Summation of time in minutes that power has been applied to
the sensor since leaving the factory.
It is the elapsed Service life of device in percentage.
The elapsed Service life of the sensor in percentage.
It monitors various diagnostic parameters which are then input
into an algorithm to calculate an estimated percent of time that
the transmitter has spent in stressful conditions.
Sensor Voltage Diagnostics.
Sensor General Diagnostics.
Process Variable selection for uploading the Track data from
sensor device.
Reserved for Honeywell use only.
Reserved for Honeywell use only.
Description
Revision 2.0