Honeywell ST700 User Manual page 45

Parameter
SENSOR_ISOLATOR_MTL
SENSOR_TYPE
SENSOR_RANGE
SENSOR_SN
SENSOR_CAL_METHOD
SENSOR_CAL_LOC
SENSOR_CAL_DATE
SENSOR_CAL_WHO
SENSOR_FILL_FLUID
SECONDARY_VALUE
SECONDARY_VALUE_UNIT
SECONDARY_VALUE_TYPE
SECONDARY_VALUE_UPPE
R_RANGE
SECONDARY_VALUE_LOW
ER_RANGE
TERTIARY_VALUE
TERTIARY_VALUE_UNIT
TERTIARY_VALUE_TYPE
TERTIARY_VALUE_UPPER_
RANGE
TERTIARY_VALUE_LOWER_
RANGE
EL_TEMPERATURE
EL_TEMP_UNIT
CAL_STATUS
QUATENARY_VALUE
TANK_RANGE
Revision 2.0 FOUNDATION Fieldbus ST 700 Pressure Transmitter User's Guide
Defines the construction material for the isolating diaphragms.
The type of sensor connected with the transducer block.
The high and low range limit values, the engineering units code, and the
number of digits to the right of the decimal point for the sensor.
The sensor serial number.
The method of last sensor calibration.
The location of the last sensor calibration. This describes the physical
location at which the calibration was performed.
The date of the last sensor calibration. It shows the calibration of that part
of the sensor that is usually wetted by the process.
The name of the person who did the last sensor calibration.
It defines the type of fill fluid used in the sensor.
The secondary value that is related to the sensor.
The engineering unit to be used with the SECONDARY_VALUE.
The type of measurement represented by the Secondary value. For
example, Pressure, Temperature.
The High range limit value of the Secondary value.
The Low range limit value of the Secondary value.
The measured value and status available to the function block.
The engineering units code of the Tertiary value.
The type of measurement represented by the Tertiary value. For Example:
Pressure, Temperature.
The High ranges limit value of the Tertiary value.
The Low range limits value of the Tertiary value.
The value and status of the measured temperature inside the electronics
housing.
The engineering units code used to display the Electronics Temperature.
The current status of the last performed calibration.
The value and status of the fluid level calculated as a polynomial of
differential pressure.
Tank Range scaling: It contains the upper and lower range of pressure
measurement of a tank. It is used primarily in level applications
specifically for the polynomial calculation.
Description
Page 31