Parameters List; Table 15: Input Selector Block Parameters - Honeywell ST700 User Manual

Parameters List

Parameter
ST_REV
TAG_DESC
STRATEGY
ALERT_KEY
MODE_BLK
BLOCK_ERR
OUT
OUT_RANGE
GRANT_DENY
STATUS_OPTI
ONS
IN_1
IN_2
IN_3
IN_4
DISABLE_1
DISABLE_2
DISABLE_3
DISABLE_4
SELECT_TYPE
Revision 2.0 FOUNDATION Fieldbus ST 700 Pressure Transmitter User's Guide

Table 15: Input Selector block parameters

The revision level of the static data associated with the function block.
The revision value increments each time a static parameter value in the
block is changed.
The user description of the application of the block.
Used to identify grouping of blocks. This data is not checked or processed
by the block.
The identification number of the plant unit. This information may be used
in the host for sorting alarms, etc.
The Actual, Target, Permitted, and Normal modes of the block.
Target: The mode to "go to"
Actual: The mode the "block is currently in"
Permitted: Allowed modes that target may take on
Normal: Most common mode for target
This parameter reflects the error status associated with the hardware or
software components associated with a block. It is a bit string, so that
multiple errors may be shown.
The block output value and status.
High and low scale values, engineering units code, and number of digits
to the right of the decimal point associated with OUT
Options for controlling access of host computers and local control panels
to operating, tuning, and alarm parameters of the block. Not used by
device.
It helps to select options for status handling and processing. The
supported status option for the integrator block is: "Use Uncertain as
Good", "Uncertain if MAN mode."
The block input value and status.
The block input value and status.
The block input value and status.
The block input value and status.
Parameter to switch off the input from being used. 0 - On, 1 - Off
Parameter to switch off the input from being used. 0 - On, 1 - Off
Parameter to switch off the input from being used. 0 - On, 1 - Off
Parameter to switch off the input from being used. 0 - On, 1 - Off
Determines the selector action: First Good, Minimum, Maximum, Middle,
and Average.
Description
Page 65