Set-Point Value; Temperature Scale Units - Fluke 9132 User Manual

100.0 C
S
1. 100.
To change to another set-point memory press "UP" or "DOWN".
4. 300.
Press "SET" to accept the new selection and access the set-point value.
S
7.2.2

Set-point Value

The set-point value may be adjusted after selecting the set-point memory and
pressing "SET".
4. 200.
If the set-point value need not be changed then press "EXIT" to resume dis-
playing the well temperature. To change the set-point value, press "SET" and
then press "UP" or "DOWN".
220.0
When the desired set-point value is reached press "SET" to accept the new
value and access the temperature scale units selection. If "EXIT" is pressed in-
stead then any changes made to the set-point will be ignored.
S
7.3

Temperature Scale Units

The temperature scale units of the controller maybe set by the user to degrees
Celsius (°C) or Fahrenheit (°F). The units are used in displaying the well tem-
perature, set-point, and proportional band.
Press "SET" after adjusting the set-point value to change display units.
Un=C
Press "UP" or "DOWN" to change the units.
Un=F
Well temperature in degrees Celsius
Access set-point memory
Set-point memory 1, 100 C currently used.
New set-point memory 4, 300 C
Accept selected set-point memory.
Set-point 4 value in C
New set-point value
Accept new set-point value
Scale units currently selected
New units selected
7 Controller Operation
Temperature Scale Units
23