Table of Contents
Advertisement
9132 Portable IR Calibrator
User's Guide
7.12.1
7.12.2
7.12.3
28
Baud Rate
The baud rate is the first parameter in the menu. The baud rate setting deter-
mines the serial communications transmission rate.
Flashes bAUd and then displays the setting
bAUd
2400 b
Current baud rate
The baud rate of the serial communications may be programmed to 300, 600,
1200, 2400, 4800, or 9600 baud. Use "UP" or "DOWN" to change the baud
rate value.
New baud rate
4800 b
Press "SET" to set the baud rate to the new value or "EXIT" to abort the opera-
tion and skip to the next parameter in the menu.
Sample Period
The sample period is the next parameter in the serial interface parameter menu.
The sample period is the time period in seconds between temperature measure-
ments transmitted from the serial interface. If the sample rate is set to 5, the in-
strument transmits the current measurement over the serial interface
approximately every five seconds. The automatic sampling is disabled with a
sample period of 0.
Flashes SPEr and then displays the setting
SPEr
SP= 1
Current sample period (seconds)
Adjust the value with "UP" or "DOWN" and then use "SET" to set the sample
rate to the displayed value. Press "EXIT" to continue without changes.
SP= 60
New sample period
Duplex Mode
The next parameter is the duplex mode. The duplex mode may be set to full du-
plex or half duplex. With full duplex any commands are executed but not ech-
oed. The duplex mode parameter is indicated by,
Flashes dUPL and then displays the setting
dUPL
d=FULL
Current duplex mode setting
Advertisement
Table of Contents
