Safety Information; Warnings - Fluke 9132 User Manual

Portable ir calibrator
Hide thumbs Also See for 9132:
Table of Contents

Advertisement

9132 Portable IR Calibrator
User's Guide
1.2
1.2.1
2
Symbol
Description
Canadian Standards Association
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-1 re-
fers to the level of Impulse Withstand Voltage protection provided. Equipment of
OVERVOLTAGE CATEGORY II is energy-consuming equipment to be supplied from
the fixed installation. Examples include household, office, and laboratory appliances.
C-TIC Australian EMC Mark
The European Waste Electrical and Electronic Equipment (WEEE) Directive
(2002/96/EC) mark.

Safety Information

Use this instrument only as specified in this manual. Otherwise, the protection
provided by the instrument may be impaired.
The following definitions apply to the terms "Warning" and "Caution".
• "Warning" identifies conditions and actions that may pose hazards to the
user.
• "Caution" identifies conditions and actions that may damage the instru-
ment being used.

Warnings

To avoid personal injury, follow these guidelines.
• BURN HAZARD – DO NOT touch the IR target surface of the unit.The
temperature of the IR target surface is the same as the actual temperature
shown on the display. If the unit is set at 500°C and the display reads
500°C, the target surface is 500°C.The top sheet metal of the instrument
may exhibit extreme temperatures for areas close to the IR target surface.
DO NOT turn off the unit at temperatures higher than 100°C. This could
create a hazardous situation. Select a set-point less than 100°C and allow
the unit to cool before turning it off.
• DO NOT operate this unit without a properly grounded, properly polar-
ized power cord.
• DO NOT connect this unit to a non-grounded, non-polarized outlet.
• HIGH VOLTAGE is used in the operation of this equipment. SEVERE
INJURY OR DEATH may result if personnel fail to observe safety pre-
cautions. Before working inside the equipment, turn the power off and
disconnect the power cord.
• Always replace the fuse with one of the same rating, voltage, and type.
• This instrument is intended for indoor use only.

Advertisement

Table of Contents
loading

Table of Contents