Set-Point Value; Temperature Scale Units; Scan; Scan Control - Fluke 9132 User Manual

6.2.2
6.3
6.4
6.4.1
info@Fluke-Direct.com
Press "SET" to accept the new selection and access the set-point value.
S
Accept selected set-point memory.

Set-point Value

The set-point value may be adjusted after selecting the set-point memory and pressing "SET".
Set-point 4 value in °C
4. 200.
If the set-point value need not be changed then press "EXIT" to resume displaying the well
temperature. To change the set-point value, press "SET" and then press "UP" or "DOWN".
New set-point value
220.0
When the desired set-point value is reached press "SET" to accept the new value and access the
temperature scale units selection. If "EXIT" is pressed instead then any changes made to the
set-point will be ignored.
S
Accept new set-point value

Temperature Scale Units

The temperature scale units of the controller maybe set by the user to degrees Celsius (°C) or
Fahrenheit (°F). The units are used in displaying the well temperature, set-point, and propor-
tional band.
Press "SET" after adjusting the set-point value to change display units.
Scale units currently selected
Un=C
Press "UP" or "DOWN" to change the units.
New units selected
Un=F

Scan

The scan rate can be set and enabled so that when the set-point is changed the dry-well heats or
cools at a specified rate (degrees per minute) until it reaches the new set-point. With the scan
disabled the dry-well heats or cools at the maximum possible rate.

Scan Control

The scan is controlled with the scan on/off function that appears in the main menu after the
temperature scale units.
Scan function off
Sc=OFF
Press "UP" or "DOWN" to toggle the scan on or off.
Scan function on
Sc=On
Fluke-Direct
6 Controller Operation
1
.com
1.888.610.7664