To change the set-point memory press "UP" or "DOWN".
Press "SET" to accept the new selection and access the set-point value.
9.2.2
Set-point Value
The set-point value may be adjusted after selecting the set-point memory and pressing
"SET".
If the set-point value is correct, hold "EXIT" to resume displaying the well
temperature. Press "UP" or "DOWN" to adjust the set-point value.
When the desired set-point value is reached press "SET" to accept the new value and
access the temperature scale units selection. If "EXIT" is pressed in stead of "SET",
any changes made to the set-point are ignored.
9.2.3
Temperature Scale Units
The temperature scale units of the controller can be set by the user to degrees Celsius
(°C) or Fahrenheit (°F). The selected units are used in displaying the well temperature,
set-point, and proportional band.
Press "SET" after adjusting the set-point value to change display units.
Press "UP" or "DOWN" to change the units.
Shop for Fluke products online at:
Well temperature in degrees Celsius
100.00C
Access set-point memory
Set-point memory 1, 25°C currently used
1. 25
New set-point memory 4, 125°C
4. 125.
Accept selected set-point memory
Set-point 4 value in °C
4 125.
New set-point value
125.00
Accept new set-point value
Scale units currently selected
Un= C
MyFlukeStore
www.
Controller Operation
Temperature Set-point
1.877.766.5412
.com
33