Introduction - Fluke 9132 User Manual

2

Introduction

The Hart Scientific 9132 Portable IR Calibrator may be used as a portable in-
strument or bench top temperature calibrator for calibrating point IR thermom-
eters. The 9132 is small enough to use in the field, and accurate enough to use
in the lab. Calibrations may be done over a range of 50°C to 500°C (122°F to
932°F). Temperature display and setability resolution of the 9132 is 0.1
degrees.
The instrument features:
• Rapid heating and cooling
• Hand strap
• RS-232 interface capability
Built in programmable features include:
• Temperature scan rate control
• Eight set-point memory
• Adjustable readout in °C or °F
The temperature is accurately controlled by Hart's digital controller. The con-
troller uses a precision platinum RTD as a sensor and controls the well temper-
ature with a solid state relay (triac) driven heater.
For improved uncertainties, a 0.125" external reference thermometer may be
used in the calibration probe hole at the top of the instrument. When using an
external reference thermometer, the unit accuracy, stability, and ambient tem-
perature effects on the surface can be minimized.
The LED front panel continuously shows the current temperature. The tempera-
ture may be easily set with the control buttons to any desired temperature
within the specified range. The instrument's multiple fault protection devices
insure user and instrument safety and protection.
The 9132 calibrator was designed for portability, low cost, and ease of opera-
tion. Through proper use the instrument will provide continued accurate cali-
bration of temperature sensors and devices. The user should be familiar with
the safety guidelines and operating procedures of the calibrator as described in
this user guide.
2 Introduction
7