Notes On Measurement; Notes On Hardware Operation - Konica Minolta CA-410 Series Instruction Manual

Notes on measurement

1. Notes on hardware operation

• Use the USB cable to connect the instrument. This software can only control probes or data processors of the CA-410
series connected by USB. It is not possible to control the probe or data processor of the CA-410 series connected by
anything other than USB with this software. Also, the CA-210/310 series can not be used with this software.
• The CA-VP410 high-sensitivity probe has a large aperture angle, which creates a higher dependence on panel directivity.
When measuring panels with high directivity, run arbitrary calibration and use the probe without rotating it from the
calibrated position.
43