Optional Accessories; Description Of Each Part Of Probes - Konica Minolta CA-410 Series Instruction Manual

Probes

4. Optional Accessories

zConversion Cable IF-A29 „
Connects a probe to a PC or PLC (sequencer) via RS-232C and inputs
synchronization signals to the probe.
How to connect: Refer to page 20.
zBNC Conversion Cable IF-A35
„
Inputs synchronization signals to the probe.
How to connect: Refer to page 20.

5. Description of Each Part of Probes

(5)
(2)
(3)
zProbe other than mini
„
Note: CA-P427, P427H, P410, and P410H have another tripod mount screw
on the front side of the ISO screw. For details, refer to the dimensions.
(1) Receptor
Make this part face perpendicular to a display to perform measurement.
(2) USB connector
For USB connection with a data processor or a PC, connect the USB cable IF-A28 supplied as a standard accessory.
(3) RS-232C connector
For RS-232C connection to a data processor, connect the mini DIN cable IF-A30/31/32 for the data processor to the
RS-232C connector.
For RS-232C connection with a PLC or PC, connect an optional conversion cable IF-A29.
Use a conversion cable IF-A29 or a BNC conversion cable IF-A35 to input the display's vertical synchronization signals, which
are used for measurement in "EXT" measurement synchronization mode.
(4) (4)
ISO screw Tripod mount screw
(1)
zMini probe
„
Note: Mini probes have screws for jigs and
cable clamps. For details, refer to the
dimensions.
12
(4) (4)
ISO screw Tripod mount screw
(2)
(3)