Indications - WEG CFW-11 User Manual

Indications

PROFINET IO defines two LEDs for status indication: one for the communication module (MS) and another for
the network (NS). Figure 2.11 describes the indication LEDs.
The MS LED (2) indicates the conditions of the module itself. Table 2.21 shows the possible states:
Status
Off
Green
Flashing green - flashes
once
Flashing green - flashes
twice
Red
Flashing red - flashes once
Flashing red - flashes once
Flashing red - flashes three
times
Flashing red - flashes three
times
Flashing green/red
The NS LED (1) indicates the conditions of the PROFINET network.
LED Status
Off
Green
Flashing green
The LINK LEDs (5 and 6) indicates the state of the physical connection of the network, as well as the activity in
the bus.
LED Status
Off
Green
Flashing green
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Figure 2.11: Description of the indication LEDs of the PROFINET module
Table 2.21: Status of the operating mode
Description
Without power supply
Normal operation
Present diagnosis
acknowledgement
Major fault
Configuration error
IP address not configured
Station name not configured
Internal error
Equipment performing self-diagnosis
Table 2.22: Status of the PROFINET network
Description
Offline
Online (RUN)
Online (STOP)
Table 2.23: Status of the connection
Description
Without link
Link
Activity in the bus
COMMENTS
No used.
Signaling used by an engineering tool to recognize
the equipment in the network.
Internal error in the communication between the
Anybus-CC module
Equipment must be reinitialized.
It indicated that the quantity of I/O words (or the
order of these words) was not correctly configured in
the master of the network.
The software IPconfig must be used to configure the
communication module
PROFINET master
configuration of the IP address.
The equipment must be configured in a PROFINET
network so that the station name is attributed by the
master of the network.
Equipment must be reinitialized.
It occurs during initialization.
Comments
Module without power supply
Without connection with the master of the network.
Connection with the master of the network
established.
Master of the network in RUN.
Connection with the master of the network
established.
Master of the network in STOP.
Comments
Without connection, without activity.
Ethernet link established but without data exchange
between master and slave.
It indicates that there is data exchange between the
master and the slave.
-
-
and drive (Exception).
address or use the
to choose the automatic